 |
|
NYLENE 200 P |
|
TECHNICAL DATA SHEET |
|
| General Description |
- Medium viscosity, general purpose nylon 6 molding resin which has been ground cryogenically to a very fine powder
- Excellent melt stability, grease resistance, and toughness
Properties
Physical Properties |
Test Method |
Units |
Dry as Molded |
|---|---|---|---|
| Mechanical Properties | Test Method |
Units |
Dry as Molded |
| Tensile Strength | D 638 |
psi (MPa) |
11,000 (76) |
| Elongation at Break | D 638 |
(%) |
50 |
| Flexural Modulus | D 790 |
psi (MPa) |
370,000 (2,550) |
| Izod Impact at 23 °C | D 256 |
ft. lb./ in. J/m |
0.7 (37) |
| Thermal Properties | Test Method | Units | Dry as Molded |
| DTUL @ 1820 kPa | D 648 |
°F (°C) |
149 (65) |
| Melt Point | D 3418 |
°F °C |
420 (215) |
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.
Issued: 2009/10/21