 |
|
NYLENE 201L |
|
TECHNICAL DATA SHEET |
|
| General Description |
- Lubricated, nucleated nylon 6 molding resin designed for faster molding cycle times and lower part shrinkage
Properties
Physical Properties |
Test Method |
Units |
Dry as Molded |
|---|---|---|---|
| Mechanical Properties | Test Method |
Units |
Dry as Molded |
| Tensile Strength | D 638 |
psi (MPa) |
11,500 (79) |
| Elongation @ Break | D638 |
(%) |
10 |
| Flexural Modulus | D790 |
psi (MPa) |
382,000 (2,630) |
| Notched Izod @ 23 °C | ftlbf/in (J/m) |
D 256 |
0.8 (45) |
| Thermal Properties | Test Method | Units | Dry as Molded |
| DTUL @ 1820 kPa | D 648 |
°F (°C) |
136 (58) |
| Melt Point | D3418 |
°F °C |
433 (223) |
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.
Issued: 2009/09/23