 |
|
NYLENE 204 HS |
|
TECHNICAL DATA SHEET |
|
| General Description |
- Heat stabilized version general purpose, fast cycling molding resin
- Crystallization initiators provide fast molding cycles through rapid melt set-up
- In addition to protection from heat degradation, parts molded from NYLENE 204 HS have better dimensional stability at moisture equilibrium than parts molded from conventional nylon
- Suitable for molding clip and fasteners, bushings, spacers, and other general purpose applications
Properties
Physical Properties |
Test Method |
Units |
Dry as Molded |
|---|---|---|---|
| Mechanical Properties | Test Method |
Units |
Dry as Molded |
| Tensile Strength | D638 |
psi MPa |
11,500 (79) |
| Elongation | D 638 |
% |
60 |
| Flexural Modulus | D 790 |
psi MPa |
400,000 (2760) |
| Notched Izod @ 23 °C | D256 |
ft. lb./ in. J/m |
0.9 (48) |
| Thermal Properties | Test Method | Units | Dry as Molded |
| DTUL @ 1820 KPa | D 648 |
°F °C |
150 (66) |
| DTUL @ 455 KPa | D 648 |
°F °C |
347 (175) |
| Melt Point | D3418 |
°F °C |
420 215 |
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.
Issued: 2009/09/23