 |
|
NYLENE 406F |
|
TECHNICAL DATA SHEET |
|
| General Description |
- Resin formulated to comply with FDA regulation 21CFR 177.1500 for food contact applications, and ANSI/NSF Standard 14
- General purpose, fast cycling molding resin
- Crystallization initiators provide fast molding cycles through rapid melt set-up
- Parts molded from 406F have better dimensional stability at moisture equilibrium than parts molded from conventional nylon
Properties
Physical Properties |
Test Method |
Units |
Dry as Molded |
|---|---|---|---|
| Mechanical Properties | Test Method |
Units |
Dry as Molded |
| Tensile Strength | D638 |
psi MPa |
10,900 (75) |
| Elongation | D638 |
% |
25 |
| Flexural Modulus | D790 |
psi MPa |
400,000 (2760) |
| Notched Izod @ 23 °C | D256 |
ft. lb./ in. J/m |
0.8 (43) |
| Thermal Properties | Test Method | Units | Dry as Molded |
| DTUL @ 264 psi/1.82 MPa | D648 |
°F °C |
160 (71) |
| DTUL @ 66 psi/0.45 MPa | D648 |
°F °C |
360 (182) |
| Melt Point | D3418 |
°F °C |
420 (215) |
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.
Issued: 2009/09/23