 |
|
NYLENE 409 |
|
TECHNICAL DATA SHEET |
|
| General Description |
- Heat stabilized version of 406 which is a general purpose, fast cycling molding resin
- Crystallization initiators provide fast molding cycles through rapid melt set-up. In addition to protection from heat degradation
- Parts molded from 409 have better dimensional stability at moisture equilibrium than parts molded from conventional nylon
- Optimum processing conditions should provide a melt temperature of 450°F-470°F at the nozzle
Properties
Physical Properties |
Test Method |
Units |
Dry as Molded |
|---|---|---|---|
| Mechanical Properties | Test Method |
Units |
Dry as Molded |
| Tensile Strength | D638 |
psi MPa |
10,900 (75) |
| Elongation at Break | D638 |
% |
25 |
| Flexural Modulus | D790 |
psi MPa |
400,000 (2760) |
| Notched Izod @ 23 °C | D256 |
ft. lb./ in. J/m |
0.8 (43) |
| Thermal Properties | Test Method | Units | Dry as Molded |
| DTUL @ 1820 KPa | D648 |
°F °C |
160 (71) |
| DTUL @ 455 KPa | D648 |
°F °C |
360 (182) |
| Melt Point | D3418 |
°F °C |
420 (215) |
| Approvals and Classifications | Approval | Rating | |
| All colors at 1.47 mm | UL 94 | V-2 | |
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.
Issued: 2009/09/23