 |
|
NYLENE 5250 HS |
|
TECHNICAL DATA SHEET |
|
| General Description |
- 50% glass fiber reinforced, heat-stabilized nylon 6 injection molding resin
- Specifically designed for maximum strength and stiffness while maintaining the heat and chemical resistance typical of nylon 6 resins
- Suitable for brackets, enclosures, valve bodies, and other uses where maximum strength and stiffness are required
Properties
Physical Properties |
Test Method |
Units |
Dry as Molded |
|---|---|---|---|
| Mechanical Properties | Test Method |
Units |
Dry as Molded |
| Tensile Strength | D638 |
psi MPa |
29,000 (200) |
| Elongation at Break | D638 |
% |
3 |
| Flexural Modulus | D790 |
psi MPa |
1,500,000 (10,345) |
| Notched Izod @ 23 °C | D256 |
ft. lb./ in. J/m |
2.0 (107) |
| Thermal Properties | Test Method | Units | Dry as Molded |
| DTUL @ 264 psi/1.82 MPa | D648 |
°F °C |
410 (210) |
| Melt Point | D3418 |
°F °C |
420 (215) |
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.
Issued: 2009/09/22