NYLENE 609
TECHNICAL DATA SHEET

 
General Description    

  • High viscosity, extrusion grade recommended for practically all types of extrusion including profile, film, and extrusion coating
  • Especially recommended for flexible packaging where as a film or coating it is used for the outside layer in multi-ply film constructions
  • Excellent melt flow and melt strength properties
  • Optimum processing conditions should permit for a melt temperature of 550 - 575°F at the die.
 

Properties   

Physical Properties
Test Method
Units
Dry as Molded
 
Mechanical Properties
Test Method
Units
Dry as Molded
Tensile Strength
D638
psi MPa
10,200
Elongation
D638
%
140
Notched Izod @ 23 °C
D256
ft. lb./ in. J/m
1.0
 
Thermal Properties Test Method Units
Dry as Molded
DTUL @ 264 psi/1.82 MPa
D648
°F °C
144
DTUL @ 66 psi/0.45 MPa
D648
°F °C
321
Melt Point
D3418
°F °C
420 (215)
 
 
Notes
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.


Issued: 2009/09/23