 |
|
NYLENE 615I |
|
TECHNICAL DATA SHEET |
|
| General Description |
- Extrusion grade nylon 6 resin suitable for film co-extrusion applications and blown film
- Excellent melt stability and good melt strength
- Superior grease resistance, toughness, resistance to abrasion, and does not absorb food odors
- Meets the requirements of FDA regulation 21CFR 177.1500 for direct food contact
Properties
Physical Properties |
Test Method |
Units |
Dry as Molded |
|---|---|---|---|
| Mechanical Properties | Test Method |
Units |
Dry as Molded |
| Elmendorf Tear | D1922 |
gm / mil |
56 |
| Yield Tensile Strength | D882 |
psi MPa |
5480 (38) |
| Ultimate Tensile Strength | D882 |
psi MPa |
8650 (60) |
| Elongation | D882 |
% |
290 |
| Secant Modulus | D882 |
psi MPa |
94,600 (652) |
| Thermal Properties | Test Method | Units | Dry as Molded |
| Melt Point | D3418 |
°F °C |
420 (215) |
| Approvals and Classifications | Approval | Rating | |
| FDA/NSF Approved | Yes | ||
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.
Issued: 2009/09/23