 |
|
NYLENE 733 |
|
TECHNICAL DATA SHEET |
|
| General Description |
- Highly impact modified nylon suitable for both molding and extrusion
- Parts molded from 733 have excellent impact strength right out of the mold without post conditioning
- Highlights include high stiffness and high strength
- Cylinder temperatures should be in the 500-550°F range.
Properties
Physical Properties |
Test Method |
Units |
Dry as Molded |
|---|---|---|---|
| Mechanical Properties | Test Method |
Units |
Dry as Molded |
| Tensile Strength | D638 |
psi MPa |
10,500 (72) |
| Elongation | D638 |
% |
200 |
| Flexural Modulus | D790 |
psi MPa |
300,000 (2,070) |
| Notched Izod @ 23 °C | D256 |
ft. lb./ in. J/m |
16.0 (855) |
| Notched Izod @ -40 °C | D256 |
ft. lb./ in. J/m |
3.0 @ -40 160 @ -40 |
| Thermal Properties | Test Method | Units | Dry as Molded |
| DTUL @ 1820 kPa | D648 |
°F °C |
142 (61) |
| Melt Point | D3418 |
°F °C |
424 (218) |
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.
Issued: 2009/09/23