 |
|
NYLENE MACH 6 |
|
TECHNICAL DATA SHEET |
|
| General Description |
- Designed for very fast cycle time molding and parts requiring high flow rates, such as long thin parts or high cavitation tools
- Low viscosity nylon 6 with special nucleation for rapid part set-up and special flow enhancers to aid in molding
- Excellent choice for parts such as wire ties, clips, fasteners, bushings and bearings
Properties
Physical Properties |
Test Method |
Units |
Dry as Molded |
|---|---|---|---|
| Mechanical Properties | Test Method |
Units |
Dry as Molded |
| Tensile Strength | D638 |
psi MPa |
10,875 (75) |
| Elongation | D638 |
% |
25 |
| Flexural Modulus | D790 |
psi MPa |
420,500 (2900) |
| Notched Izod @ 23 °C | D256 |
ft. lb./ in. J/m |
0.75 (40) |
| Thermal Properties | Test Method | Units | Dry as Molded |
| DTUL @ 64 psi/0.45 MPa | D648 |
°F °C |
356 (180) |
| Melt Point | D3418 |
°F °C |
428 (220) |
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.
Issued: 2009/09/23