![]() |
|
NYLENE NX4301 |
|
TECHNICAL DATA SHEET |
General Description |
- High viscosity, UV stabilized extrusion grade nylon resistant to degradation by ultraviolet light
- The elevated quality of UV resistance is attributed to highly uniform dispersion of 2% carbon black
- With an ASTM viscosity of 200, NX4301 has very good melt flow and melt strength characteristics which are important for profile extrusion
- Optimum processing conditions should permit for a melt temperature of 550 - 575°F at the die. (Available in black only)
Properties
Physical Properties |
Test Method |
Units |
Dry as Molded |
---|---|---|---|
Mechanical Properties | Test Method |
Units |
Dry as Molded |
Tensile Strength | D638 |
psi MPa |
10,200 |
Elongation | D638 |
% |
140 |
Notched Izod @ 23 °C | D256 |
ft. lb./ in. J/m |
1.0 |
Flexural Strength | D790 |
psi |
17,000 |
Thermal Properties | Test Method | Units | Dry as Molded |
HDT @ 264 psi | D648 |
°F |
144 |
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.
Issued: 2009/09/23